Featured

Kris Holm Percussion Leg Armour

Kris Holm Percussion Leg Armour is the first armour designed for the specific demands of unicyclists.

Keep your skin where it belongs: on your body. KH Percussion Leg Armour is just what you need. New design improvements include a larger leg wraparound, protecting more of your legs; improved knee design and softer straps for improved riding comfort.

Select Features:

Full coverage to both the front and back of the leg
Special attention was paid to the vulnerable (and sensitive!) inner knee area in the design of this armour. Extra padding protects your knees from frame bashes.
Polyurethane inside-leg patches to resist tyre abrasion
Vented flexible knees are low profile to avoid the unicycle fork crown
Knee padding extends high above the knee and resists sagging
Cool and well-vented behind the knee
Quick and easy to take on/off
Durable 1100 Denier Ballistics nylon lined with wicking polyester
Machine-washable in front-load washer or by hand
Weight: 650 g (size L)

Warning: use of this equipment will not guarantee protection against injury. Ride within your limits!

Sizing Guide

To find your size measure the length of your shin from foot to just below the kneecap and the circumference of your leg just above the ankle (ie where the armour would sit at its lowest point) and just above the knee.

Size	KH Percussion (Shin length in cm)	Top Opening (cm)	Bottom Opening (cm)	661 4x4 leg armour for comparison (Shin length in cm)
S	28	40	20	27.5
M	30	43	23	28.8
L	31.3	47	24	32.5
XL	33.1	50	25	33.1
XXL	37	52	27

The chart below shows a general guide based on your height. In reality, size preference will vary based on your leg length and circumference.

Size	Height
S	150 cm - 160 cm (5'0" - 5'4")
M	160 cm - 170 cm (5'4" - 5'8")
L	170 cm - 180 cm (5'8" - 5'11')
XL	>180 cm (>5'11")

SixSixOne 4x4 leg armor	KH Percussion Armor
Cheap front face fabric prone to fraying	High quality, 1100 denier ballistics nylon face fabric, with additional patch reinforcement in high wear areas.
Cheap liner fabric prone to wear	High quality, wicking fabric similar to bike jersey material
Seams are prone to wear, on the inside of the legs	Minimal stitching, to resist wear. The inside leg reinforcement patch stitching is triple stitched and stitch lines are placed in grooves between shin plastic panels, to resist abrasion.
Thin foam padding does not provide sufficient impact protection to meet European CE standards	Armor has high quality EVA foam padding and meets CE protection standards.
Low knees prone to sagging	Higher over the knees, with a low-stretch connector patch from the knee to shin to resist snagging
Knee plastic can be prone to cutting through the face fabric with extended use	Higher quality face fabric, reinforcement patches, and rounded corners on the knee plastic prevent wear from occurring with use.
Velcro prone to catching on a unicycle fork crown and wearing out	Unique knee strap design routes the knee straps to the outside of the knee. This keeps the knee pad from catching on the fork crown, and prevents the straps from wearing out

Hot and sweaty behind the knee	Wraparound leg protection gives coverage where you need it (on the calf), while leaving the back of the knee cool open for venting.
Hook and loop leg straps make it time consuming to put on the armor.	High quality stretch nylon straps are soft fabric for comfort, and are designed to be quick and easy to put on.